Resetting chips on a 4000, 4800, 7600, 9600, 7800, 9800 Continuous Flow System
These Auto Reset chips actually reset themselves when the ink level recorded on the chip
falls below the 5% level. However, the printer will not accept this automatic reset until
the Ink Change Lever is lifted on the printer.
Let the monitored ink level go down and down until it gets to the point where the LED begins to
blink (approx 5%). At this point the chip resets itself to full, but the printer will not
believe this. So it gives a cartridge not recognized error. At this time the
the Ink Lever must be raised for a few seconds and then put back down. This is the
point the cartridges could have been changed and therefore the printer must accept the
new ink level on the chips.
Do not remove the cartridge, just lift the Ink Lever when the LED begins to blink.
|
