| |
| PREPARATION: |
| |
| 1. |
Remove BCI-62 Photo ink tank cartridge from printer. |
| |
| 2. |
Set the cartridge on a flat surface with plenty of newspaper underneath it.
The 6 exit ports should be pointing up. The top row takes the standard colors and the
bottom or middle row takes the photo colors. |
| |
| REFILL |
| |
| 3. |
Prepare the yellow squeeze bottle by putting the Needle cap on it. Make sure the needle
cap is tight, use o'ring supplied. Attach the pink needle to the needle cap. |
| |
| 4. |
If you have a syringe in your kit, attach the needle and draw about 6 cc of ink into
the syringe. The 2 oz squeeze bottle holds 60 cc and the 1 oz about 30 cc. |
| |
| 5. |
5. Let the ink drip onto the yellow exit port. Don't put more than 6 cc's in the
front holes. Be careful that it does not over flow. When it has taken all of the 6 cc
or won't take anymore ink, turn the cartridge upside down, and let any excess in drain
off. Don't worry, the sponge will retain the correct amount. After dripping stops,
seal the port with black electrical tape. |
| |
| 6. |
Put away the yellow ink, clean every thing with yellow ink on it with warm water. Set
up the next bottle or syringe for the next color. |
| |
| 7. |
Repeat the above procedure for the magenta and cyan. Use 10 cc's for the photo yellow,
photo magenta, and photo cyan inks. Make sure you put the right color ink in the correct
exit port. Just a few drops of ink in the wrong port and the cartridge will be
worthless. |
| |
|
When you are done, you can remove the tape from each exit port.
Let the cartridge sit for at least 15 minutes in its installed position (exit ports down) before re-installing in printer..
For storage, put a piece of black electrical tape across the exit ports.
|
| |
