 |
Step 1:
Remove cartridge from printer.
Step 2:
Scrape off the round plastic seal as shown on the left, using a flat blade. When seal is
removed, the ball bearing will be exposed.
Step 3:
Push the ball into the cartridge as shown on the right, using the "Black Entry
Tool" provided.
|
|
 |
Step 5:
If you have a syringe in your kit, attach the pink needle (not the 4" needle) and
draw about 10 cc of ink into the syringe.
Step 6:
Fill the cartridge through the hole created by pushing the ball in, as shown on the
left. DO NOT OVER FILL. If the cartridge was empty, it will take about 30 cc of ink
to fill it, maybe a little less.
Step 7:
When the filling operation is complete, squeeze the sides of the cartridge tightly. While
holding the sides, insert a new ball into the seat, as shown on the right.
Turn cartridge upsidedown then release the squeeze. DO NOT RELEASE SQUEEZE UNTIL BALL IS IN
PLACE AND CARTRIDGE IS UPSIDEDOWN (actually right side up now).
A nice idea is to use a Pony Clamp to squeeze sides of cartridge, see our
Accessories Page. It provides the squeeze and keeps cartridge upright in the process.
|
 |
